John Lewis JLBIGH602 Bedienungsanleitung PDF herunterladen (Seite 17)

• If you change from liquid gas to natural gas

G20 20 mbar, undo the by-pass screw

approximately 1/4 of a turn.

Warning! Make sure the flame

does not go out when you quickly

turn the knob from the

maximum position to the

minimum position.

Electrical connection

• Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

• The appliance must not be connected with an

extension cable, an adapter or a multiple

socket. There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed to

the side of the cabinet, in order to avoid any

contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains

plug after the installation.

Electrical Requirements

Permanent electrical installation must agree with

the latest I.E.E. Regulations and local Electricity

Board regulations. For your own safety the

installation must be done by a qualified

electrician (e.g. your local Electricity Board, or a

contractor who is on the roll of the National

Inspection Council for Electrical Installation

Contracting [NICEIC]).

The manufacturer refuses to be

held responsible, if these safety

measures are not abided by.

Supply connections:

This hob has to be connected to 230 — 240 V

( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

•

L — Live terminal

•

N — Neutral terminal

•

or E — Earth terminal

Before carrying out the connection, make sure:

1. The limiter valve and the electrical system

can take the appliance load (see the rating

plate)

2. The supply system is equipped with an

efficient earth connection in compliance

with the current standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the

appliance installed.

The appliance is supplied with a 3 core flexible

powercable with a 3 amp plug. If it is necessary

to change the fuse, use a 3 amp ASTA-approved

(BS 1362) fuse.

AB

C

D

E

A) Green and Yellow

B) 3 amp fuse

C) Brown

D) Cord clamp

E) Blue

The wires in the cord are coloured as follows:

Green and yellow - Earth

Blue - Neutral

Brown - Live

Hob user manual 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare